LCD Controller Overview
The Pokemon Mini LCD is a serial display with it's own on-board framebuffer, and display settings. These are all abstracted by the PRC, which handles display copies ($1000 ~ $12FF) and other various functions. No commercial roms directly access the display, relying on the PRC and BIOS to perform the various communications. This allows for the PM to have hardware changes without having to rely on the same display controller.
The display is driven by two data ports, $20FE and $20FF. Both ports are read\write, the only difference between them is one sets the CTRL line when accessing the data port on the LCD. The port is 8-bits wide, and has a small set of standard commands.
The LCD is probably using the on-glass controller IC SSD1828 or something very simliar.
The controller got 96x65 Graphic Display Data RAM (GDDRAM). The additional RAM is for an unused symbol driver. The PM most likely uses a parallel interface to the controller, but serial interface might be available on the connector of the LCD.
LCD Controller Commands
Lower case "x" denotes parameters used by the command. A question mark "?" denotes bits that are don't care.
The commands in this list are verified to work. The SSD1828 datasheets holds much more commands that are hard to verify or didn't work on the PM.
|0000 xxxx||Set Column (low nibble)||xxxx = Column (low nibble)|
|0001 xxxx||Set Column (high nibble)||xxxx = Column (high nibble)|
|1011 xxxx||Set Page||xxxx = Page (0-7, each page is 8px high)|
|1000 0001||Set Contrast||Next write to FE or FF sets Constrast Level ($00-$3F)|
|1010 011x||Invert Display select||x = 0 (normal) or 1 (invert)|
|1010 111x||Display ON/OFF||x = 0 (off) or 1 (on)|
|1010 010x||Entire Display ON/OFF||x = 0 (normal) or 1 (all Pixels on)|
|1100 x???||Set scan direction (rows)||x = 0 (normal from row 0 to 63) or 1 (from row 63 to 0 - horizontal mirror)|
Data can be read and written from/to the LCD at any time. The programmer should make sure that the page and column address pointers are pointing to the correct location.
When data was read or written the column address automatically increases by one.
After executing page address and both of the column address set operations data can be written to the selected location.